Gas spring used in performance evaluation of automobile

Air tightness: 80 ± 2 × 4H to 20 ± 2 ℃ × 2H → -40 ± 2 × 4H to 20 ± 2 ℃ × 2h, after 2cycles, measurement of mechanical properties, the rate of change of F1 should be less than 8%.

Durability: 4~6 /min 25000 cycles, each cycle 2500, measurement of mechanical properties, the rate of change of F1 should be less than 8%.

Corrosion resistance: the minimum compression state, neutral salt spray test of 48h,gas spring coating shall be in accordance with B 5.2 as specified in GB6461, the coating should accord with the regulations in GB1740 level.

Tensile strength: tensile strength of gas spring should accord with the regulations in table, after the test of each connector should not break or fall off phenomenon,mechanical properties should also be consistent with the force displacement curve.

Tensile member section size,mm Pull,N
φ5 2000
φ6 3000
φ8 4500
φ10 6000
φ12 10000

Send your message to us:

INQUIRY NOW
  • * CAPTCHA: Please select the Car


Post time: May-09-2017
INQUIRY NOW
  • * CAPTCHA: Please select the Key